Calibration Ampoules

Calibration-AmpoulesCalibration-Ampoules

Calibration Ampoules

  • Using these gases it may be possible to cross-calibrate sensors for other gases and using a beakers of different volumes rating. It is possible of to Calibration at different ranges than the concentration mentioned on the Ampule.
  • Before use, it is important that both the ampoules and the calibration beaker are clean and dry. Ampoules should not be used if the glass is cracked or fractured and the calibration beaker should not be used unless the lid is tight fitting.
  • Because some gases (e.g. Cl2) are easily absorbed it is recommended that the internal surfaces of the calibration beaker Be permeated with the calibration gas prior to actual calibration.
  • This is most easily accomplished by placing an ampoule in the beaker, placing the beaker over the sensor and breaking the ampoule as if performing a normal calibration routine. The ampoule should be left in place for approximately 5 minutes.
  • Special mixtures to customer specification can be supplied subjecttoa minimum quantity of Mini Spancanspermixture.
Category:

Calibration-Ampoules Finds applications in wide variety of industries where Detection and control of dust level is critical for the safety, Maintenance , Equipment operation, Plant Efficiency and or the environment.

It provides Reliable and Economical Detection of leak and filter Failures in Powder and Bulk Solids industries Stack guard has LED visual Indication and relay output to maximize its user-friendliness and automation capabilities.

It incorporates a specially designed adjustable damping system that increases its response time and prevents False alarms

Specification

Water Capacity 0.5Ltr
Fill Pressure/Burst Pressure 21 bar/55 bar
Quantity of Gas available for use 10Ltrand20Ltr
Container wall material Aluminium
Weight when full-* Less than 300 gms.

The above Parameter and Ranges are only indicative. Endee will build up and supply the analyser with Parameters, range and features to any Practical Configuration.

Note : Specifications and Features will vary with application. The above are established and validated during design, but are not to be construed as test criteria for every product. Due to endee’s commitment to research, design and product improvement, specifications are subject to change without notice

Reviews

There are no reviews yet.

Be the first to review “Calibration Ampoules”

Your email address will not be published. Required fields are marked *

Scroll to Top