for a variety of common atmospheric hazards. It utilizes a point to point writing architectures whereby each detector head, alarm / shutdown device and remote system is individually wired to the control unit. This is best choice for small systems, typically less than 20 points, where the sensors are located in relative close proximity to the central control unit.
The system is designed for easy expansion by means of plug in sensor modules. Remote 98 series transmitters are available in non explosion proof or explosion proof versions. Both versions can be with or without digital readouts.
The systems includes built in digital readouts at the controller. Other standard features include two independently adjustable alarm set points per channel, bright LED alarm light indicators and relay contacts for fault, low and high alarm conditions; common and channel specific 4-20mA analog outputs for communicating sensor data to other systems.
Endee Model 8420 X rack / panel mount control enclosure along with Micro controller based digital control modules is designed to serve as a host control system for remote mount gas detection sensor transmitters. The single channel modular designed can be configured for any combination of gases. All control modules are plug in front panel accessible for easy maintenance and repair. A "Blank Plate" can be installed on any unused channel until that channel is needed at some future date.
The Model 8420 X includes an integral and modular power supply, three digit indicator serves as both a power on indicator and a direct reading display of the gas concentration. Alarm set points are software adjustable in 1 PPM / % increments across the range of detection. The reset switch reseta all alarm relays.