Fixed gas Monitors Flame Proof   download

FLP-Gas-Transmitters   download


  • Indicating or Non Indicating.
  • Discrete Analog 4- 20mA.
  • Compatible with PLC, Scada and DCS.
  • Power Supply 24VDC
  • Gas Specific, Long life Sensor.

Relay contacts could be typically used to actuate remote alarms, increase ventilation, shut off gas supply, or shut down a process. Should it not be feasible to install the sensor at the desired location because of maintenance, or operational consideration, a suction based sampling system can be employed. The Sensors Detectors are of very sturdy construction, with weather proof or ex-proof housings and are designed to serve for several years under normal Operating Conditions.

Detection Principle Application Based Electrochemical , Semiconductor or PID
Response Time <5seconds
Zero drift 0.2% Fs
Accuracy 2%Fs
Operating Voltage 22-30 Volt DC
Operating Temperature 0-50 C
Terminations PCB mounted terminal blocks toaccept 1.5mm wires
Display lnbuilt 0.5n LCD
Output 4- 20 mA Linear/0 - lVolts DC (V)/RS232/RS485 2 wire (Electrochernical sensor based, Dew point, Humidity, Temp, Moisture, Vapour Pressure) 3 Wire (Cumbustible, Toxic Gas)
Power Consumption 2 wire: 0.5 W max./ 3 wire: 3.6 W max.
Max. Load 600Ohms
Mounting 2" Pipe (U clamps will be provided)

The above Parameter and Ranges are only indicative. Endee will build up and supply the analyser with Parameters, range and features to any Practical Configuration.

Note : Specifications and Features will vary with application. The above are established and validated during design, but are not to be construed as test criteria for every product. Due to endee's commitment to research, design and product improvement, specifications are subject to change without notice

Add a review