1-2-Channel-Controller 
- Settablc through Software
- Parameter of Measuremen
- Maximum Range
- Unit of Measurement
- Alarm Level
- Self Diagnostic Functional Test
- Accepts 4-20 rnA signal
- Provides 24 Volts DC to Power Remote Transmitter
- Serial Communication Output RS 232 / 485
- Expandable to Two Parameters
It is designed to serve as a host control system for remotely mounted Gas or other Process Transmitters. It is loaded with .software operated exclusive features, Parameters, Maximum Range, unit of measurement & alarm level are all settable in the field to enhance its universal utility & application.
The Model PIC 6002 is a micro controller based Intelligent Indicator controller accepts 4 20 mA input from remotely located transmitter as well as provides 24 volts DC to power the same. It utilizes a point-to-point wiring architecture whereby each Transmitter / Detector Hez id, Alarm/ shutdown device or remote system is individually wired to the control unit. This is the best choice for: >mall systems, where the sensors are located in relative close proximity to the control unit.
| Input | 4-20 mAcurrent Loops |
|---|---|
| Displays | Alphanumeric8X2 |
| Indications LED | Poweron, Test, High Alarm |
| Output | 24 Volts DC to power transmitter |
| Alarm | Adjustable over Full Range |
| Power Input | 100-300 VAC47-60Hz Standard/24VDCOptional |
| Power Consumption | <5 watts |
| Output | Serial Rs-485/ 232 Discrete relaysforfault,lowand high alarm. |
| Electrical Classifications | NEMA1 panel mount |
| Operating Temperature | -10°Cto55°C |
| Humidity Range | 0 to 95% RH, non-condensing |
| Dimension | 96X96X160 |
| Panel Cutout | 89X89 |
| Warranty | One year |
| Field Settable | (i) Parameter (All Gases, for special consult Endee) (ii) Maximum Range (iii)Unitof Measurement PPM, LEL, Percent (iv) Alarm Level |
The above Parameter and Ranges are only indicative. Endee will build up and supply the analyser with Parameters, range and features to any Practical Configuration.
Note : Specifications and Features will vary with application. The above are established and validated during design, but are not to be construed as test criteria for every product. Due to endee's commitment to research, design and product improvement, specifications are subject to change without notice